Modelling a chair seat

[J Parr]

How would I go about this?

I have done the frameworks just need the seat and back (2 parts)

[Muggs]

Hi L Parr,

Make a "swoopy" thing exit the sketch.
Call it Swoopy thing-1.
Highlight the Swoopy thing-1 and on the reference geometry toolbar click
Plane and then the endpoint of the swoopy thing.
Next, on that plane make Swoopy thing-2.
It really doesn't mater what it looks like apearenty because you gave us no
parameters.
Now sweep Swoopy thing-2 along Swoopy thing-1.

That's it, Your done!
Muggs

"J Parr" <voodoochile3@blueyonder.co.uk> wrote in message
news:E5ucf.24$mb.3@fe3.news.blueyonder.co.uk...

How would I go about this?

I have done the frameworks just need the seat and back (2 parts)

[John Layne]

J Parr wrote:

How would I go about this?

I have done the frameworks just need the seat and back (2 parts)

This is a very open question, a lot more detail from you is required.

John Layne
www.solidengineering.co.nz

[Adrian Brooks]

hi I Parr if you e-mail me a sketch I see if I can help

regards Adrian
"J Parr" <voodoochile3@blueyonder.co.uk> wrote in message
news:E5ucf.24$mb.3@fe3.news.blueyonder.co.uk...

How would I go about this?

I have done the frameworks just need the seat and back (2 parts)