2004 Network installation wizard/standalone licenses possibl

[nobo]

Hello,

I would like to prepare a standard installation of AutoCAD 2004 with the Network Installation Wizard, but is it possible to make a standard installation when you have a number of standalone user licenses and no network license? (can you prepare the installation to install the application and then enter the specific serial number and start the registration?)

Regards Nob

[Cy Shuster]

Yes. I believe it would be easier if you had a "multi-seat" serial number
in this case, so it could be the same for each seat. Don't remember if you
can have different S/N's for each with the NIW; check the Network
Installation Guide.

--Cy--

"nobo" <nospam@address.withheld> wrote in message
news:17655432.1098310364143.JavaMail.jive@jiveforu m2.autodesk.com...

Hello,

I would like to prepare a standard installation of AutoCAD 2004 with the
Network Installation Wizard, but is it possible to make a standard
installation when you have a number of standalone user licenses and no
network license? (can you prepare the installation to install the
application and then enter the specific serial number and start the
registration?)

Regards Nob

[shobhit]

Currently, that's how I roll out Autodesk software. I build a network deployment image but I have it configured for a standalone install. With multi-seat standalones, this makes Autodesk software a little bit more bearable. Refer to your Network Guide that comes with your Autodesk software for the step by step instructions.

Best regards,

Shobhit Baadkar
Director of Business Development
CVIS, Inc.
http://www.cvis.com

[nobo]

Hello,

Thank you for your replys.
I forgot to mention that I am from Holland. After trying for some time I have learned that the Network Installaton Wizard only works for a multiseat license if you want to make an insallation for more then 1 machine. And this licensetype is not available in Europe......

Regards,
Nob