WF2- Simplified Rep on Drawing

[Pierluigi Diletti]

I'm trying to define a drawing view of a part using
a simplified representation.
But it's not possible to modify the view.
In the panel "View States" the option "simplified representation" is not
available.
It was possible on 2001 and now, on WF2, it's only possible for assembly.
Could anyone help me ??
Thnks in advance

Pier

[Jeff Howard]

No help until WF3. Look at the thread "PTC strikes again :-(" from a few
days ago.

[Pierluigi Diletti]

Thanks a lot !!
Pier

"Jeff Howard" <jeff4136@mindspring.com> ha scritto nel messaggio
news:TibFe.4257$0C.2630@newsread3.news.pas.earthli nk.net...

No help until WF3. Look at the thread "PTC strikes again :-(" from a few
days ago.

PTC's "workaround" for this in WF1 and WF2 was to use a family table of
the part. Of course, most users found this to be unacceptable since it
created another model. As Jeff mentioned, it is back in WF3.
Unfortunately, PTC pushed the release date back 6 months, from Sept to
Mar 06.
Regards