Bury License Issue Resolved

[John Schmidt]

Hmmm - I couldn't find my previous messages here via NNTP, and this
newsgroup isn't available via the web interface??

Anyway, a reboot of the license server cleared up the hung license issue.

Thanks for all the other suggestions too.

John

[Anne Brown]

Hi John -

Your post is still on the NNTP groups. You perhaps need to adjust
your OE software so that it is not set to the default. The
default is not showing messages over 5 days old.

Try this direct link to the network group via HTTP -
http://discussion.autodesk.com/forum.jspa?forumID=24.


How to bury license?
Date:
Tue, 17 Aug 2004 09:45:56 -0700
From:
"John Schmidt" <johnaec-nospam-@pacbell.net>
Newsgroups:
autodesk.autocad.network

---
Anne Brown
Discussion Groups Administrator
Autodesk, Inc.

John Schmidt wrote:

Hmmm - I couldn't find my previous messages here via NNTP, and this
newsgroup isn't available via the web interface??

Anyway, a reboot of the license server cleared up the hung license issue.

Thanks for all the other suggestions too.

John

[John Schmidt]

Thanks Anne - I didn't realize I had to go into the AutoCAD subgroups to
find Networking - I just assumed it would be in the primary list.

I vastly prefer the NNTP access, but haven't figured out how to get it to go
back and get messages that have already scrolled off at my end. No worry
though, now that I know about the HTTP method of going through the
sub-listings if I need to search for older messages.

Thanks - John

"Anne Brown" <discussion.support@autodesk.com> wrote in message
news:412F90A1.512813E4@autodesk.com...

Hi John -

Your post is still on the NNTP groups. You perhaps need to adjust
your OE software so that it is not set to the default. The
default is not showing messages over 5 days old.

Try this direct link to the network group via HTTP -
http://discussion.autodesk.com/forum.jspa?forumID=24.


How to bury license?
Date:
Tue, 17 Aug 2004 09:45:56 -0700
From:
"John Schmidt" <johnaec-nospam-@pacbell.net
Newsgroups:
autodesk.autocad.network

---
Anne Brown
Discussion Groups Administrator
Autodesk, Inc.

John Schmidt wrote:

Hmmm - I couldn't find my previous messages here via NNTP, and this
newsgroup isn't available via the web interface??

Anyway, a reboot of the license server cleared up the hung license
issue.

Thanks for all the other suggestions too.

John

[Anne Brown]

John -

From a saved message by Kent Keller:

In Outlook Express, if you want to get all the headers in one
shot, rmb on the group, and go to Properties >> Local Files Tab

Reset. That will remove everything from the group. Then RMB on the group and go to Synchronization Settings >> Headers Only.

Finally without going into the group by left clicking during all
this, go to Tools >> Synchronize All. Allow it to run and it
should get all the headers in one shot.
---
Anne Brown
Discussion Groups Administrator
Autodesk, Inc.

John Schmidt wrote:

Thanks Anne - I didn't realize I had to go into the AutoCAD subgroups to
find Networking - I just assumed it would be in the primary list.

I vastly prefer the NNTP access, but haven't figured out how to get it to go
back and get messages that have already scrolled off at my end. (snip)