Plotting using a macro

[dmck]

Hi,
I'm currently running AutoCAD 2004 with a HPDJ550 A0 Colour plotter and HP LaserJet 5110. I have quick plot buttons set up that invoke a script to import page setups from a separate drawing held on the network. and print the current drawing. eg A1 MONO LANDSCAPE OTO

However only the A1 plot button works. All the rest plot with a very large off set only giving me the top right hand quarter of the drawing. If i run through the command line and invoke the page setup the drawing prints fine. I have checked all my settings and to my knowledge they are correct. I have seen other posts regarding this issue but none have been resolved. This has been an ongoing problem. Any Idea's?

[Dean Saadallah]

Post your customization.

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--

[dmck]

Plot MACRO
^C^CFILEDIA;0;CMDDIA;0;SCRIPT;"G:/CAD Support/CAD Development 2004/AutoCAD Batch Routines/mesl import page setups.scr";-plot;n;;MESL A0 MONO LANDSCAPE OTO;;;;;FILEDIA;1;CMDDIA;1

Import Page Seups Script
__Expert
5
_-psetupin
"G:/CAD Support/Standard Drawing Sheets/MESL BASE DRAWING REV 1.dwg"
"*"
_Expert
0
FILEDIA
1

[dmck]

I should also add that my A1 Plotting Macro Button Works fine. Also there is no difference between the A1 Macro Code/PageSetup except the pagesetup name and obvious things like PaperSize.

Dave