AutoCad 2002 not plotting Bi-directional on HP 1050c

[Jaco_Dess]

I cant seem to get my AutoCad 2002 to plot to a HP 1050 Bi-Directional. Am i just missing some setting or something?

Thanks
Jaco

[Dean Saadallah]

You provide no system details, AutoCAD plot setup details, or
plotter/network setup information in your post.

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--

[Andrew Carie]

In general terms, the 1050c only prints bi-directional in monochrome mode.
(It will print bi-directional color in draft mode.) I use two different pc3
files, one for monochrome drawings and one for color drawings. You must go
into printer properties through the pc3 file to the options tab and tell it
to print "color as grayscale". Save this file as your monochrome pc3 file.
It does not matter if your ctb file is set to all black or that the light
for monochrome is lit up on your printer. Software settings override
hardware settings. You still must check the grayscale box in printer
properties.)

For complete details go to:
http://h20000.www2.hp.com/bizsupport...ectID=bpp03466
This spells it all out for each media type.

Andrew Carie

"Dean Saadallah" <info from pendean> wrote in message
news:41a0e537$1_1@newsprd01...

You provide no system details, AutoCAD plot setup details, or
plotter/network setup information in your post.

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--

[jean_michel]

If you're referencing to duplex printing, it has never been supported by acad, event thought with 2005.