| Author |
Message |
Pierluigi Diletti
Guest
|
 Posted:
Mon Jul 25, 2005 8:10 pm Post subject:
WF2- Simplified Rep on Drawing |
|
|
I'm trying to define a drawing view of a part using
a simplified representation.
But it's not possible to modify the view.
In the panel "View States" the option "simplified representation" is not
available.
It was possible on 2001 and now, on WF2, it's only possible for assembly.
Could anyone help me ??
Thnks in advance
Pier
|
|
| Back to top |
|
 |
Jeff Howard
Guest
|
| Posted:
Mon Jul 25, 2005 8:10 pm Post subject:
Re: WF2- Simplified Rep on Drawing |
|
|
No help until WF3. Look at the thread "PTC strikes again :-(" from a few
days ago. |
|
| Back to top |
|
|
Pierluigi Diletti
Guest
|
| Posted:
Tue Jul 26, 2005 12:10 am Post subject:
Re: WF2- Simplified Rep on Drawing |
|
|
Thanks a lot !!
Pier
"Jeff Howard" <jeff4136@mindspring.com> ha scritto nel messaggio
news:TibFe.4257$0C.2630@newsread3.news.pas.earthlink.net...
| Quote: | No help until WF3. Look at the thread "PTC strikes again :-(" from a few
days ago.
|
|
|
| Back to top |
|
|
Guest
|
| Posted:
Fri Jul 29, 2005 4:10 pm Post subject:
Re: WF2- Simplified Rep on Drawing |
|
|
PTC's "workaround" for this in WF1 and WF2 was to use a family table of
the part. Of course, most users found this to be unacceptable since it
created another model. As Jeff mentioned, it is back in WF3.
Unfortunately, PTC pushed the release date back 6 months, from Sept to
Mar 06.
Regards |
|
| Back to top |
|
|
|
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in