Svenn Are Bjerkem
Guest
|
 Posted:
Tue Nov 02, 2004 2:44 pm Post subject:
Corner tool: How to reset / delete measurement list? |
|
|
Hi,
When starting the corner tool from ADE, it gets the outputs to plot from
the "outputs to be plotted" in ADE. It also get the technology from the
"Model Setup". I have to manually delete the outputs that I don't want
to have in my plotted corner run. If I save my setup to a dcf, the
corner tool does not delete the unwanted signals when I reread the dcf
file, but it *adds* them to the existing. After deleting the signals
manually, which is a pain as I can't select more signals and then press
delete, corner tool behaves nicely until next start of ADE. Then it is
the same over again.
Is there a "wipe my brain" skill command for corner tool that I can
include at the top of the dcf file?
Kind regards,
--
Svenn
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in