| Author |
Message |
Guest
|
 Posted:
Tue Nov 15, 2005 9:10 am Post subject:
Decimal seperator |
|
|
I have set my decimal separator to "," in my options so that all the
dimensions in the drawings appear with this separator. When I insert a
hole callout on my drawing sheet, I find the decimal separator to be
"."
Is there any means to get the decimal separator that I set for hole
callouts?
|
|
| Back to top |
|
 |
cadguru
Guest
|
| Posted:
Tue Nov 15, 2005 9:10 am Post subject:
Re: Decimal seperator |
|
|
My Seperator is consistent throughout hole callouts and dimensions.
What version of SolidWorks are you using? I am on 2006 SP0.
Cadguru
<cnkk_kumar@indiatimes.com> wrote in message
news:1132043364.838773.82120@z14g2000cwz.googlegroups.com...
| Quote: | I have set my decimal separator to "," in my options so that all the
dimensions in the drawings appear with this separator. When I insert a
hole callout on my drawing sheet, I find the decimal separator to be
"."
Is there any means to get the decimal separator that I set for hole
callouts?
|
|
|
| Back to top |
|
|
Guest
|
| Posted:
Wed Nov 16, 2005 9:10 am Post subject:
Re: Decimal seperator |
|
|
I am using Solidworks 2006 SP 1.0
|
|
| Back to top |
|
|
cadguru
Guest
|
| Posted:
Wed Nov 16, 2005 9:10 pm Post subject:
Re: Decimal seperator |
|
|
Interesting. I am using SP.0 2006. I could run the Service pack and see if
it acts like yours.
Cadguru
<cnkk_kumar@indiatimes.com> wrote in message
news:1132115857.260880.77980@g47g2000cwa.googlegroups.com...
| Quote: |
I am using Solidworks 2006 SP 1.0
|
|
|
| Back to top |
|
|
matt
Guest
|
| Posted:
Wed Nov 16, 2005 9:10 pm Post subject:
Re: Decimal seperator |
|
|
Take a look at Tools > Options > General > Use system separator for
dimensions. Depending on the country / language your OS is installed
with, it maybe defaulting to a system setting rather than the SW
setting. |
|
| Back to top |
|
|
|
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in