| Author |
Message |
yozotrinity
Guest
|
 Posted:
Wed Jan 12, 2005 5:06 pm Post subject:
Toolbox SW2003 problem |
|
|
I'll be thankfull if anyone can help about this:
When using bolts or nuts from SW toolbox in assembly mode, and when using
smart fastener, using it on a single pc seems OK,
but when I try to open the assembly on another PC that has toolbox
installed, all the fasteners, nuts, bolts seem to loose the
reference/configurations.
The only way to correct this is to copy the entire toolbox to the other PC.
Does anybody know how to solve this problem?
Thanks.
|
|
| Back to top |
|
 |
cadman800
Guest
|
| Posted:
Wed Jan 12, 2005 7:54 pm Post subject:
Re: Toolbox SW2003 problem |
|
|
"yozotrinity" <yozotrinity@yahoo.com> wrote in message
news:cs344m$5e1$1@ls219.htnet.hr...
| Quote: | I'll be thankfull if anyone can help about this:
When using bolts or nuts from SW toolbox in assembly mode, and when using
smart fastener, using it on a single pc seems OK,
but when I try to open the assembly on another PC that has toolbox
installed, all the fasteners, nuts, bolts seem to loose the
reference/configurations.
The only way to correct this is to copy the entire toolbox to the other
PC.
Does anybody know how to solve this problem?
Thanks.
|
Toolbox needs to be installed on the network so that everyone is looking at
the same parts. I think you can find documetation on deploying that type of
set up on the solidworks website. Down side is that toolbox runs slower on
the network install
Cheers
Dennis
> |
|
| Back to top |
|
|
JF
Guest
|
| Posted:
Wed Jan 12, 2005 8:27 pm Post subject:
Re: Toolbox SW2003 problem |
|
|
This is a VERY good question!
I just had a very embarrassing moment thanks to toolbox.
(I should have check it, but was short on time.)
I had worked on an assembly for two weeks, copied the assembly to
my notebook, took it over to my customers for them to approve.
When I opened it up, toolbox could not find the configurations
that were in the original assembly! DANG IT!
Shouldn't toolbox just ask if you want to create the "missing"
configurations?
"yozotrinity" <yozotrinity@yahoo.com> wrote in message
news:cs344m$5e1$1@ls219.htnet.hr...
| Quote: | I'll be thankfull if anyone can help about this:
When using bolts or nuts from SW toolbox in assembly mode, and when using
smart fastener, using it on a single pc seems OK,
but when I try to open the assembly on another PC that has toolbox
installed, all the fasteners, nuts, bolts seem to loose the
reference/configurations.
The only way to correct this is to copy the entire toolbox to the other
PC.
Does anybody know how to solve this problem?
Thanks.
|
|
|
| Back to top |
|
|
Dale Dunn
Guest
|
|
| Back to top |
|
|
|
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in