Guest
|
 Posted:
Sat Jan 08, 2005 10:22 pm Post subject:
"Undo" function gone...SW2004 SP5 |
|
|
Hi,
Ok, don't know what I did now, but "Undo" is gone. When I go
to "Edit" it says "Can't Undo" and it's grayed out.
This was here before I installed SP5 from SP3 (SW2004). Now,
mind you I don't normally use this because I enveer maake mystakys,
but it's good for show...
Thanks...
Mike Tripoli
|
|
Kman
Guest
|
| Posted:
Sun Jan 09, 2005 2:13 am Post subject:
Re: "Undo" function gone...SW2004 SP5 |
|
|
I don't make mistakes either so I had to open SolidWorks and verify. Undo
edit from menu or undo tool button works for me (i.e. parts) 2004/SP5.0
Kman
<miket@hell.com> wrote in message
news:nf50u0tabhm4bjmc7lrnqgjlh93nkoue9g@4ax.com...
| Quote: | Hi,
Ok, don't know what I did now, but "Undo" is gone. When I go
to "Edit" it says "Can't Undo" and it's grayed out.
This was here before I installed SP5 from SP3 (SW2004). Now,
mind you I don't normally use this because I enveer maake mystakys,
but it's good for show...
Thanks...
Mike Tripoli |
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in