Sandman
Guest
|
 Posted:
Thu May 12, 2005 4:10 pm Post subject:
How to change the drawing order for lines and symbols? |
|
|
Hi folks,
I have some 2D DGN files, they include lines and cells.
The cells (is a circle) are "under" the lines, so it seems, the line
cut the circle cell in two peaces.
So, how to put the cells up?
Thanks,
Regards,
Artur
|
|
Phil Chouinard [Bentley]
Guest
|
| Posted:
Fri May 13, 2005 6:27 am Post subject:
Re: How to change the drawing order for lines and symbols? |
|
|
If you are using MicroStation V8, put the cells in a Selection Set and go to Edit > Bring to Front.
BTW, if you haven't yet, you might want to check out the Bentley discussion groups -- see http://discussion.bentley.com/help/ for
more information.
Phil Chouinard [www.Bentley.com]
"Sandman" <gralla@gmx.net> wrote in message news:1115908687.711649.151840@z14g2000cwz.googlegroups.com...
| Quote: | Hi folks,
I have some 2D DGN files, they include lines and cells.
The cells (is a circle) are "under" the lines, so it seems, the line
cut the circle cell in two peaces.
So, how to put the cells up?
Thanks,
Regards,
Artur |
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in