TUSHAR PATEL
Guest
|
 Posted:
Wed Mar 30, 2005 6:36 pm Post subject:
GAP TOLERANCE IN BOUNDARY HATCH |
|
|
I HAVE SET MY GAP TOLERANCE IN THE BOUNDARY HATCH DIALOG BOX = 10units
NOW MY GAP DURING HATCH IS EQUAL TO 5mm
SO I WILL GET THE MESSAGE DURING CREATION OF HATCH THAT " CLOSE BOUNDARY NOT FOUND ETC." & AT LAST I HAVE ONE CHECK BOX WITH MESSAGE "REMEMBER THIS DECISION " IF I ON THAT CHECK BOX NOW AUTOCAD WILL NEVER ASK ME ABOVE MESSAGE IF MY GAP IS LESS THAN THE GAP TOLERANCE.
"BUT IF I WANT THAT MESSAGE AGAIN" WHAT IS THE WAY? IS THERE ANY SYSTEM VARIABLE? PLEASE. HELP ME OUT OF THIS PROBLEM........
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in