CADForums.net

Fellippe · Guest

I'm in a bit of a bind here...we're using Autocad 2004.

Out of nowhere, the Plotter doesn't show the typical paper sizes (24 X 36 D, 36 X 48 E, etc). Instead it shows different sizes, typical for normal printers....every computer on the network is experiencing this problem, not an isolated case.

I verified all the paths (Tools --> Options --> Files --> Printer support File Path--> Printer Configuration Search Path; Printer description file search path; Plot style table search path). These haven't changed.

I tried the "repair" program from the control panel, and reset the settings above. Didn't do anything.

The thing I noticed is that after I select the Plotter.pc3 file, right next to the IP address, it refers to the plotter as one of our regular printers! It is the only device that is incorrectly listed... I don't know how to change this setting.....anyone know how to do this?

Finally, if all else fails, how do you integrate the OEM drivers
to make this work from scratch. We are using an HP Designjet 1050C.

Thanks for any help!

Dean Saadallah · Guest

Sounds like someone messed up your original PC3 file: time to recreate it
and lock it up.

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--

Fellippe · Guest

How do you recreate the Pc3 file?

And how would you lock it up afterwards?

wookie · Guest

In Acad, go File/Plotter Manager, then run the add a plotter wizzard. It will make a PC3. Put it on your network in a dedicated directory for pc3 files, and get your IT dude to make the directory read only, so no one can stuff it up.
While you are at it, make sure your stb/ctb files are read only too. Anyone who wants special settings (if they are allowed to) should have to make a new file.

Fellippe · Guest

Thanks for everybody's help....you've solved my problem. :)

	CADForums.net Forum Index -> Printing	All times are GMT
Page 1 of 1