CADForums.net

Jason Rhymes · Guest

I've made a plot button to -plot using the command line and it doesn't work.
(may have something to do with why my publish isn't working).
If I go into the plot dialog box and change page setup to <none> the button
works but if I use a page setup name nothing gets printed but it prints from
the dialog box.

This doesn't work:

Detailed plot configuration? [Yes/No] <No>:
Enter a layout name or [?] <Cover>:
Enter a page setup name <Xerox 11x17 Mono>:
Enter an output device name or [?] <Xerox WorkCentre Pro 32 C PS.pc3>:
Write the plot to a file [Yes/No] <N>:
Save changes to page setup [Yes/No]? <N>
Proceed with plot [Yes/No] <Y>:

This does work:

Detailed plot configuration? [Yes/No] <No>:
Enter a layout name or [?] <Cover>:
Enter a page setup name <>:
Enter an output device name or [?] <Xerox WorkCentre Pro 32 C PS.pc3>:
Write the plot to a file [Yes/No] <N>:
Save changes to page setup [Yes/No]? <N>
Proceed with plot [Yes/No] <Y>:

Dean Saadallah · Guest

While you wait...

Since you went to the trouble to Automate, why not go all the way and
recreate all the 11x17 mono requirements too? Simply answer YES to perform a
detailed plot configuration, that way you will always know what you will get
all the time and not be at the mercy of a pagesetup change.

--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
--

Jason Rhymes · Guest

I was able to correct the problem by rebuilding my page setup for the Xerox
11x17 Mono and saving it again. It also fixed some of my Publish problems.

	CADForums.net Forum Index -> Printing	All times are GMT
Page 1 of 1