Marc Clamage
Guest
|
 Posted:
Wed Feb 23, 2005 8:42 pm Post subject:
Offset Problems |
|
|
I just loaded ADT 2004 onto my new laptop and am working on the 3D Job From
Hell (i.e., started it 2 and a half years ago in R14, upgraded it to 2004
last year, writing it back to 2002 so my client can read it on his machine,
50,000 sf site, xrefs out the wazoo, three separate buildings, etc. etc.). I
was working in iso and drew a polyline along the top of a 3D object at an
elevation of, let's say, 5'. I then offset the line by one inch and the
offset object failed to appear. After zooming out a little I found it, at an
elevation of 0! This happens predictably -- the new object is always at
elevation 0, regardless of the elevation of the original polyline. Is there
a toggle I need to switch? Doesn't happen on my old machine. A pain in the
butt but the new machine is sufficiently superior to the old one that I'd
prefer to keep working on it.
Thanks,
--
Marc Clamage
www.emasary.com
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in