| Author |
Message |
pcyco
Guest
|
 Posted:
Wed Dec 29, 2004 8:34 pm Post subject:
chamfer, fillet, problems |
|
|
in one drawing i have the problem when i chamfer 2 polyliness from two different layers. they always placed on the "0" layer after chamfering them.
does anyone know the sys. var. or anything else about this problem
thanks for helping
pc
|
|
| Back to top |
|
 |
Matt
Guest
|
| Posted:
Wed Dec 29, 2004 8:47 pm Post subject:
Re: chamfer, fillet, problems |
|
|
Is the first pline you pick on layer "0". Typically when you chamfer/filet
plines from 2 different layer, acad will force the new pline onto the layer
of the first item picked. I scanned a bit and couldn't find a variable for
that would force the new pline to the "0" layer (which isn't saying there
isn't one).
Matt
"pcyco" <nospam@address.withheld> wrote in message
news:8457280.1104334501404.JavaMail.jive@jiveforum1.autodesk.com...
| Quote: | in one drawing i have the problem when i chamfer 2 polyliness from two
different layers. they always placed on the "0" layer after chamfering them.
does anyone know the sys. var. or anything else about this problem
thanks for helping
pc |
|
|
| Back to top |
|
|
pcyco
Guest
|
| Posted:
Wed Dec 29, 2004 8:54 pm Post subject:
Re: chamfer, fillet, problems |
|
|
hallo again
a part of the problem is fixed now.
this problem appears only if one line is placed on the 0 layer.
but there is no difference by picking the line first or not.
if both lines are not on the 0 layer(but on different layers) this probloem does not appear.
thanks again
pc
|
|
| Back to top |
|
|
Matt
Guest
|
| Posted:
Wed Dec 29, 2004 9:04 pm Post subject:
Re: chamfer, fillet, problems |
|
|
No problem. Thanks to you for the "this problem appears only if one line is
placed on the 0 layer. but there is no difference by picking the line first
or not." tidbit.
Matt
"pcyco" <nospam@address.withheld> wrote in message
news:20866521.1104335677978.JavaMail.jive@jiveforum1.autodesk.com...
| Quote: | hallo again
a part of the problem is fixed now.
this problem appears only if one line is placed on the 0 layer.
but there is no difference by picking the line first or not.
if both lines are not on the 0 layer(but on different layers) this
probloem does not appear.
thanks again
pc |
|
|
| Back to top |
|
|
Dean Saadallah
Guest
|
| Posted:
Mon Jan 03, 2005 6:39 pm Post subject:
Re: chamfer, fillet, problems |
|
|
First one you pick controls 'layer' setting of the final Pline when one of
the entities you try to fillet/chamfer is a pline.
It's always worked like that, there is no variable around it.
--
Dean Saadallah
Add-on products for LT
http://www.pendean.com/lt
-- |
|
| Back to top |
|
|
|
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in