jimmy
Guest
|
 Posted:
Thu Nov 25, 2004 2:20 am Post subject:
error in using ocnprint |
|
|
Hi,
I always use Ocnprint to save data in cadence. Sometime I encountered
such a problem. Let me describe it using an example.
If I want to run a transident analysis for 100us. During the long
simulation, I like to use direct plot to view the on-going results.
The problem is: if I viewed the data at 20us. Then if I want to use
direct plot to view the data again later, I can not see data after
20us. If I use Ocnprint to save data, I can only save valid data up to
20us. However, i can still use result browser to view updated data.
I have no idea what is wrong?
Thank you for your help,
jimmy li
|
|
Erik Wanta
Guest
|
| Posted:
Sun Nov 28, 2004 9:49 pm Post subject:
Re: error in using ocnprint |
|
|
Jimmy:
I have not tried it but I see a few functions that might help.
simDrain()
artFlush()
---
Erik
lizh@ece.orst.edu (jimmy) wrote in message news:<c8960588.0411241320.7dc12864@posting.google.com>...
| Quote: | Hi,
I always use Ocnprint to save data in cadence. Sometime I encountered
such a problem. Let me describe it using an example.
If I want to run a transident analysis for 100us. During the long
simulation, I like to use direct plot to view the on-going results.
The problem is: if I viewed the data at 20us. Then if I want to use
direct plot to view the data again later, I can not see data after
20us. If I use Ocnprint to save data, I can only save valid data up to
20us. However, i can still use result browser to view updated data.
I have no idea what is wrong?
Thank you for your help,
jimmy li |
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in