| Author |
Message |
CKERIDES
Guest
|
 Posted:
Fri Nov 19, 2004 3:40 am Post subject:
WF 2.0 - Drawing |
|
|
Created a X-section in a drawing on-the-fly by offsetting a surface. Looking
for a way to modify the dimension used to create the offset surface. This was
possible in previous versions but I don't see where to modify the X-section in
2.0
|
|
| Back to top |
|
 |
Jeff Howard
Guest
|
| Posted:
Fri Nov 19, 2004 5:03 am Post subject:
Re: WF 2.0 - Drawing |
|
|
| Quote: | Created a X-section in a drawing on-the-fly by offsetting a surface.
Looking
for a way to modify the dimension used to create the offset surface. This
was
possible in previous versions but I don't see where to modify the
X-section in
2.0
|
This might be going over my head (never created a XSec that way), but if
the XSec ends up in the model file, model sectioning has been moved to the
View Manager in WF2. |
|
| Back to top |
|
|
David Janes
Guest
|
| Posted:
Fri Nov 19, 2004 5:33 am Post subject:
Re: WF 2.0 - Drawing |
|
|
: "CKERIDES" <ckerides@aol.com> wrote
: Created a X-section in a drawing on-the-fly by offsetting a surface. Looking
: for a way to modify the dimension used to create the offset surface. This was
: possible in previous versions but I don't see where to modify the X-section in
: 2.0
In the part, try 'View>View Manager>Xsec'. Pick the cross section you wish to
redefine then 'Edit>Redifine>Redefine', check the box labelled Section, select
Done and then, pick Sketch. This will get you into sketcher where you can modify
the offset geometry.
David Janes
|
|
| Back to top |
|
|
CKERIDES
Guest
|
| Posted:
Mon Nov 29, 2004 9:53 pm Post subject:
Re: WF 2.0 - Drawing |
|
|
| Thanks - This worked |
|
| Back to top |
|
|
|
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in