Rich Keitz
Guest
|
 Posted:
Wed Dec 01, 2004 7:28 pm Post subject:
FLEX License question |
|
|
The main office is in Williamsburg and the branch office is in Richmond. We
have a private T1 connecting sites. I want to share the licenses between
offices and also have redundancy.
For example, I want to put 5 licenses in Richmond and 20 licenses in
Williamsburg and allow each site to draw for the other site if an additional
license is needed on a short term basis.
Additionally, I want to have a redundant FlexLM at each location.
This scenario will allow both offices to function in the case of a T1
failure, creating two smaller pools instead of a single distributed pool.
It will also allow the offices to function in the event a FlewLM server goes
down for any reason at both locations.
Is this configuration possible? If so, where can I find documentation?
Rich Keitz
|
|
jerry milana (Autodesk Co
Guest
|
| Posted:
Thu Dec 02, 2004 12:23 am Post subject:
Re: FLEX License question |
|
|
Rich,
We do not recommend mixing the redundant and distributed models. Consider a
10/15 license split or using a third server to do a 5/10/10 split to
minimize the impact of a single server failure. The result will be more
predictable than redundancy and will be easier to administrate.
--
Jerry Milana,
Autodesk Consulting
"Rich Keitz" <rkeitz@aesva.com> wrote in message
news:41add511_3@newsprd01...
| Quote: | The main office is in Williamsburg and the branch office is in Richmond.
We
have a private T1 connecting sites. I want to share the licenses between
offices and also have redundancy.
For example, I want to put 5 licenses in Richmond and 20 licenses in
Williamsburg and allow each site to draw for the other site if an
additional
license is needed on a short term basis.
Additionally, I want to have a redundant FlexLM at each location.
This scenario will allow both offices to function in the case of a T1
failure, creating two smaller pools instead of a single distributed pool.
It will also allow the offices to function in the event a FlewLM server
goes
down for any reason at both locations.
Is this configuration possible? If so, where can I find documentation?
Rich Keitz
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in